2103 subaru outback draw tite hitch
Thread the fish wire through the hitch attachment hole and out of the access hole. Thread carriage bolts through the access holes The access holes will be used to fish-wire the provided carriage bolts into the hitch attachment holes.
2103 SUBARU OUTBACK DRAW TITE HITCH DRIVER
Using the 1 ?-inch hole saw, drill an access hole in the frame on the driver and passenger side roughly two inches from the forwardmost plug hole. Take out the rubber plugs from the holes on the bottom of the frame after the heat shields are removed. Save the bolts, as you will be reinstalling the heat shields after the hitch is installed. Use a 10mm socket or Phillips head screwdriver to remove the heat shields found above each muffler. You may need to use soapy water to loosen the rods. There are two above each exhaust muffler and another above the center exhaust pipe. Remove the isolator rods from the rubber exhaust hangers using the exhaust pliers. Make sure the strap or rope can be adjusted. Tie a rope or strap around the center exhaust pipe and attach it to a sturdy engine component under the body, like a crossmember. Subaru Outback (2010-2018) hitch installation steps 1. making it capable of hauling small and large loads. The hitch has a max trailer weight of 4,000 lb. The Draw-Tite 75673 is a class 3, bolt-on trailer hitch designed for the 2018 Subaru Outback. Follow these basic steps to begin hauling all kinds of hitch-mounted accessories with your Subaru Outback today. Installing a trailer hitch on a 2018 Subaru Outback requires a few tools, a Draw-Tite 75673 custom trailer hitch and about 45 minutes to complete the installation. Move-In Online Today! Move-In Online: Get Started.